Sentry Industries PT40 User Manual download pdf (Page 24)

Command Line Interface

Logging In

Logging in through Telnet requires directing the Telnet client to the configured IP address of the unit.

Logging in through the Console (RS232) port requires the use of a terminal or terminal emulation

software configured to support ANSI or VT100 and a supported data rate (300, 1200, 2400, 4800, 9600,

19200, 38400, 57600, or 115200 BPS) - 8 data bits-no parity-one stop bit and Device Ready output

signal (DTR or DSR).

To log in by RS-232 or Telnet:

1. Press Enter. The following appears, where x.xx is the firmware version:

Sentry Version x.xx

Username:

NOTE: Logging in by Telnet will automatically open a session. It is not necessary to press Enter.

2. At the Username: and Password: prompts, enter a valid username and password. And press Enter.

You are given three attempts to enter a valid username and password combination. If all three fail,

the session ends.

When you enter a valid username and password, the command prompt (Sentry:) appears. If a location

identifier was defined, it will be displayed before the Sentry: prompt. See Creating a location

description on page 33 for more information.

You may enter commands in any combination of uppercase and lowercase. You must enter all

command characters correctly; there are no command abbreviations. There are two types of commands:

operations and administration. A user must have administrative privileges to use the administration

commands. The following tables list and briefly describe each command.

Operations Command Summary

Command Description

On Turns one or more outlets on

Off Turns one or more outlets off

Reboot Reboots one or more outlets

Status Displays the on/off status of one or more outlets

ILoad Displays the total cumulative input load

Istat Displays the status of the infeeds

Connect Connects to a serial/Pass-Thru port

Logout Ends a session

Quit Ends a session

List Outlets Lists all accessible outlets for the current user

List Ports Lists all accessible serial/Pass-Thru ports for the current user

List Group Lists all assigned outlets for a group name

List Groups Lists all accessible groups for the current user

Administrative Command Summary

Add Grouptouser Grants a user access to one or more groups

Add Outlettogroup Adds an outlet to a group name

Add Outlettouser Grants a user access to one or all outlets

Add Porttouser Grants a user access to one or all serial/Pass-Thru ports

Create Group Adds a group name

Create User Adds a user account

20 • Operations Sentry Commander - PT40

Installation and Operations Manual

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Comments to this Manuals

No comments

Sentry Industries PT40 User Manual Page 24

Comments to this Manuals